UMX Turbo Timber

Transmitter - DX8 G2

1. Verify Throttle
   1. Throttle Stick is at its lowest position
   2. Throttle Cut is On ( Switch H ↓ )
2. Turn on the power to the Transmitter
3. Wait 5 - 10 seconds.

UMX Turbo Timber

1. Plug in battery
   1. Plane needs to be motionless for 5 seconds for the AS3X system to initialize
2. Verify Radio Link
   1. Red LED is on steady and not flashing (Behind rudder servo, left rear)
   2. Blue LED is on steady (Behind elevator servo, right side)
3. Check surface deflection with stick movement
4. Verify Safe Mode functionality
   1. Hold Plane
   2. Set Throttle Cut Off ( Switch H ↑ )
   3. Set Safe Mode, Blue LED ( Switch G ↑ )
   4. Pulse throttle above 25%
      Safe Mode will not activate until throttle is advanced above 25%
   5. Rotate Plane, verify surfaces move and hold their position to level the plane
5. Verify AS3X Mode functionality
   1. Set AS3X Mode, Red LED ( Switch G ↓ )
   2. Rotate Plane, verify surfaces do not move to level plane

Notes

Key

	↑  Up   Arrow - Switch pushed back
	↓  Down Arrow - Switch pulled forward


Mode Select / Receiver Board

	Safe Mode = Blue LED = Sw G ↑ 
	AS3X Mode = Red  LED = Sw G ↓


Throttle Cut
	Off = Sw H ↑
	On  = Sw H ↓